Take complete control of your Proforge 2S. Effortlessly start, stop and monitor prints over your Wi-Fi network with the open-source OctoPi Control Center.
The system runs on a Raspberry Pi with the Raspberry Pi camera which is housed and mounted to a swivelling aluminium bracket which can be mounted to either the Bed or Gantry.
The Proforge 2S connects to the Raspberry Pi which in turn connects and runs through an internet browser on the same Wi-Fi network.
Use the Camera to not only monitor the progress of prints but also create stunning time lapses like this:
- Steel camera mounting brackets
- Raspberry Pi Camera
- Raspberry Pi Camera ribbon cables and adapter
- 4GB Micro SD Card / Adapter / Case
- Power and ethernet cable
- Fasteners and mountings
- Raspberry Pi 3B+ (if selected)
The build manual can be found here.